The Cooltek Eins.

Cooltek's new range of units, number Eins, Zwei and Drei, bring to market fine, affordable cases with a stylish look.

The crystal pattern in full-mesh design offers excellent effects for luxury and cooling.

Three 120mm fans can be mounted on the front and the internal temperature can be kept normal. The already pre-installed 120mm fan on the back serves as support. Optionally, you can install two 120mm or two 140mm fans on the top of the case to further support temperature regulation. In the sense of "Open the Wind Way" fresh air is sucked through the front and the floor by the fans and then discharged on the back and lid as exhaust air again. Also for the installation of water cooling has been taken care of in this case. In the front you can install radiators with a size of 120mm or 240mm, in the cover a 120mm, 140mm or 240mm radiator and at the back a 120mm radiator.

The magnetic dust filter on the lid and the bottom pull-out filter are easy to remove and clean. With the I / O panel at the top, you have easy access even when the case is under your desk. The I / O panel has two USB2.0 ports, one USB3.0 ports, and HD audio and microphone access.

Both ATX, M-ATX and ITX motherboards can be installed in this case. In the movable hard drive cage of the Cooltek One you can install two HDD or two SSD hard drives. In addition, it is also possible to mount two SSD hard drives on the back of the motherboard bracket.

With a mounting depth of 205mm and a length of 358mm, coolers with a max. Height of 168mm and VGA cards with a length of 350mm can be installed. In the lower part of the case, next to the HDD cage, it is possible to attach ATX power supplies with a length up to 205mm.