MPN KF316C10BK2/16
Artikelnr. W126824202
Lagernivå
FURY KF316C10BK2/16 is a kit of two 1G x 64-bit (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components per module. Total kit capacity is 16GB. Each module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. Each 240-pin DIMM uses gold contact fingers.
JEDEC standard 1.5V Power Supply
VDDQ = 1.5V
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
N/No
Unregistered (unbuffered)
10
PC/Server
Heatsink
N/No
16 GB
DDR3
Y/Yes
Y/Yes
Dual-channel
1600 MHz
240-pin DIMM
2 x 8 GB
1.5 V
512M x 8
260 Nanosecond
37,5 Nanosecond
48,125 Nanosecond
Y/Yes
84733020
0 - 85 °C
-55 - 100 °C
84733020
0,1 kg
0,072 kg
0,71 cm
3,4 cm
13,33 cm
1 År
FURY KF316C10BK2/16 is a kit of two 1G x 64-bit (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components per module. Total kit capacity is 16GB. Each module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. Each 240-pin DIMM uses gold contact fingers.
*Produktdatan ovan tillhandahålls av Icecat. EET kan inte hållas ansvarigt för fel i samband med detta.